CONTENTS
1. Normal/Special service condition 2. Altitude and enclosure
1. Handling 2. Storage
1. Fixed type 2. Draw-out type 3. Dust cover 4. Precaution and installation
1. Manual operation 2. Electrical operation 3. Draw-in operation 4. Draw-out operation
1. Inspection and maintenance cycle 2. Defects and troubleshooting guideline
1. Internal structure and components 2. Basic function and breaking operation
A. Safety Precaution
…………………………………………………………………………………………….…
2~4
B. Service condition.
………………………………………………………………………………………...………
5~6
C. Structure and Operation
………………………………………………...…………………………………
7~9
D. Types and rating
…………………………………………………………………………………………………
10~13
E. Unpacking
………………………………………………………………………………………………………………
14~15
F. Handling and Storage
……………………………………………………………….………………………
16~17
G. Installation
………………………………………………………………………………………………………………
18~19
H. Operation
………………………………………………………….………………………………………………………
20~23
M. Inspection and troubleshooting
………………………………………….…………………………
43~44
N. Wiring diagram of control circuit
……………………………………………………………………
45
I. Trip unit externals and configuration
………………………………………...……………………
24~25
1. Knob setting 2.Key and LED Configuration
J. Trip unit setting
………………………………………………………………………………………………………
26~31
1. Protection 2. Operation characteristic 3. Rating plug
L. Characteristic curves
……………………………………………………………………………………………
38~42
1. Long-time protection 2. short-time protection
3.Instantaneous / Ground-fault protection 4. IDMTL 5. Pre-trip alarm
1. Safety precaution 2. Caution 3. Danger 4. Warning
1. Receiving 2. Unpacking 3. Check point and caution
1. Types 2. Ratings
K. The operation of Trip unit
…………………………………………………………………...………………
32~37
1. Menu tree 2. LCD segment 3. Button configuration 4. Measurement display
5. Relay setting display
O. Other operation
……………………………………………………………………………………………………
46~47
1
1. KEYLOCK operation 2. ERMS
To Next Page
Loading...