LS SV150iS5-4 User Manual

Chapter 2 - Operation
30
2.3.2 Procedure for Setting Data (7-Segment Keypad)
n In DRV Group:
1. Rotate the encoder knob until the desired parameter code is displayed.
2. Press [PROG/ENT] key to go into the programming mode, then the display blinks.
3. Press [SHIFT/ESC] key to move the cursor to the desired digit.
4. Rotate the encoder knob to change the data.
5. Press [PROG/ENT] key to enter the changed data.
n In FUN1 Group:
1. Rotate the encoder knob until parameter code ‘20’ is displayed in drive group.
2. Press [PROG/ENT] key to go into the FUN1 group.
3. Rotate the encoder knob until the desired parameter code is displayed.
4. Press [PROG/ENT] key to go into the programming mode, then the display blinks.
5. Press [SHIFT/ESC] key to move the cursor to the desired digit.
6. Rotate the encoder knob to change the data.
7. Press [PROG/ENT] key to enter the changed data.
n In FUN2 Group:
1. Rotate the encoder knob until parameter code ‘21’ is displayed in drive group.
2. Go to step 2 of ‘In FUN1 Group’ above, and follow the rest procedure.
n In I/O Group:
1. Rotate the encoder knob until parameter code ‘22’ is displayed in drive group.
2. Go to step 2 of ‘In FUN1 Group’ above, and follow the rest procedure.

LS SV150iS5-4 Specifications

General

Brand	LS
Model	SV150iS5-4
Category	Controller
Language	English