LTH Electronics MXD70 Series - Page 293

Setup
- 36 -
MXD70 Electrodeless Conductivity
Setup and Operating Guide
Setup
Setpoints Setup
( available options vary with card type and configuration )
Setpoint 1 Setpoint 2 Setpoint 3 Setpoint 4 Setpoint 5 Setpoint 6 Channel Input Source Trigger High Value Low Value USP Pre-Trigger Mode Cycle Time Proportional Band Delay Hysteresis Dose Alarm Dose Alarm Time Initial Charge Charge Time Charge Access Alarm Mode Clean Duration Clean Interval Clean Mode Clean Recovery Clean Delay