To Next PageTo Next Page
Need help?Do you have a question about the LTH Electronics MXD70 Series and is the answer not in the manual?
Details the warranty for defects in materials and workmanship for three years.
States compliance with European EMC Directive 2014/30/EU using BS EN 61326-1:2013.
States compliance with European Low Voltage Directive 2014/35/EU using BS EN 61010-1:2010.
Specifies Modbus support, RTU/ASCII formats, node address, and baud rates.
Enables backing up/restoring configuration, logging readings, and software upgrades.
Details instrument installation and safe connection to power and auxiliary equipment.
Provides instructions for electrical connections, emphasizing safety precautions.
Recommendations for minimizing EMI/RFI interference and listing noise sources.
Explains how to install sensor input and output option add-in cards for expandability.
Describes flush mounting the instrument in a panel and securing it with screw clamps.
Details AC or DC power supply connections, including daisy-chaining and voltage limits.
Explains how to connect up to 6 current outputs (A to F) for load resistance and noise immunity.
Details connecting up to 6 relays (change over or normally open), electrical isolation, and fuse requirements.
Details the warranty for defects in materials and workmanship for three years.
States compliance with European EMC Directive 2014/30/EU using BS EN 61326-1:2013.
States compliance with European Low Voltage Directive 2014/35/EU using BS EN 61010-1:2010.
Specifies Modbus support, RTU/ASCII formats, node address, and baud rates.
Enables backing up/restoring configuration, logging readings, and software upgrades.
Details instrument installation and safe connection to power and auxiliary equipment.
Provides instructions for electrical connections, emphasizing safety precautions.
Recommendations for minimizing EMI/RFI interference and listing noise sources.
Explains how to install sensor input and output option add-in cards for expandability.
Describes flush mounting the instrument in a panel and securing it with screw clamps.
Details AC or DC power supply connections, including daisy-chaining and voltage limits.
Explains how to connect up to 6 current outputs (A to F) for load resistance and noise immunity.
Details connecting up to 6 relays (change over or normally open), electrical isolation, and fuse requirements.
General| Diode Test | Yes |
|---|---|
| Power Supply | 9V battery |
| Operating Temperature | 0°C to 40°C |
| DC Voltage Range | 1000 V |
| AC Voltage Range | 750V |
| DC Current Range | 0.1μA to 10A |
| AC Current Range | 0.1μA to 10A |
| Continuity Test | Yes |
| Display | LCD |
| Measurement Range | Varies depending on the selected range (see individual ranges above) |
| Resolution | Varies by range |
| Accuracy | ±(0.5% + 2 digits) |
