Faults
- 44 -
MXD70 Electrodeless Conductivity
Setup and Operating Guide
Faults
Setpoint Errors
E180 SP1 Dose Alarm Error
E190 SP2
The Setpoint has been dosing for longer than the Dose Alarm time as defined in
the setpoint menu.
E200 SP3
E210 SP4
E220 SP5
E230 SP6
E181 to E184 SP1 For Future Use
E191 to E194 SP2
E201 to E204 SP3
E211 to E214 SP4
E221 to E224 SP5
E231 to E234 SP6
E185 SP1 Store A Checksum Error
E195 SP2
The Store A Save for the Channel associated with this Setpoint has become
corrupted. Check the setpoint's settings in the setpoint menu and then save the
settings again in the Channel's Store A in the Save/Restore menu.
E205 SP3
E215 SP4
E225 SP5
E235 SP6
E186 SP1 Store B Checksum Error
E196 SP2
The Store B Save for the Channel associated with this Setpoint has become
corrupted. Check the setpoint's settings in the setpoint menu and then save the
settings again in the Channel's Store B in the Save/Restore menu.
E206 SP3
E216 SP4
E226 SP5
E236 SP6
E187 SP1 Setup Checksum Error
E197 SP2
The Setup for this Setpoint has become corrupted. Check and correct the setpoint
settings and turn the unit off and on again. If the message persists please consult
with your supplier.
E207 SP3
E217 SP4
E227 SP5
E237 SP6
E188 SP1 SD Card Checksum Error
E198 SP2
The SD Card store from which this Setpoint was restored from has become
corrupted. Check the setpoint's settings in the setpoint menu and then save the
settings again to the SD card store.
E208 SP3
E218 SP4
E228 SP5
E238 SP6
To Next Page
Loading...
Need help?
General
