LTH Electronics MXD70 Series User Manual

Channel Calibration
MXD70 Dissolved Oxygen
Setup and Operating Guide
- 27 -
Channel Calibration
Calibration Manual Temperature Input
This setting allows a different fixed temperature
value to be used when calibrating. Makes it easier to
calibrate a sensor outside of the process
environment.
NB. If the manual temperature input is changed in
the channel setup menu then the calibration manual
temperature is changed to the same value.
Only available when the temperature compensation
mode has been set to manual in the channel setup
menu.
/ – Increase / Decrease Digit

– Select Next Digit
EXIT
– Cancel
– Save Value
Calibration Units
The instrument can be calibrated in any of the
following units:
 % (saturation)
 ppm (concentration)
 pO2 (partial pressure of Oxygen)
 mmHg (millimetres of Mercury)
 mg/l (milligrams per litre)
NB. If the operating units are changed in the channel
setup menu then the calibration units are
automatically changed to the same.
/ – Select Option
EXIT
– Cancel
– Save Selection

LTH Electronics MXD70 Series Specifications

General

Brand	LTH Electronics
Model	MXD70 Series
Category	Measuring Instruments
Language	English