Channel Calibration
MXD70 Auxiliary mA Input
Setup and Operating Guide
- 21 -
Channel Calibration
4 mA Input Calibration
Set the known current input to 4mA and press enter
to initiate a calibration.
Only available when the input mode is set to 4 –
20mA in the channel setup menu.
PREV
– Go to Previous Calibration Point
SKIP
– Skip to Next Calibration Point
EXIT
– Exit Calibration Without Saving
– Initiate Calibration
20 mA Input Calibration
Set the known current input to 20mA and press enter
to initiate a calibration.
Only available when the input mode is set to 4 –
20mA in the channel setup menu.
PREV
– Go to Previous Calibration Point
SKIP
– Skip to Next Calibration Point
EXIT
– Exit Calibration Without Saving
– Initiate Calibration
Sensor Solution Calibration
The Sensor Solution calibration enables the user to
adjust the sensor reading to match a known input.
The current reading can be seen in the pop-up
window and is adjusted by pressing the up and down
arrows. When the reading is correct press the enter
button to store the calibration.
/ – Adjust the Reading Up or Down
EXIT
– Cancel
– Save Calibration
To Next Page
Loading...
