LTS 83 K-ET Series - RS-485 and Controller Connection

DigitalVideoRecorderQuickStartGuide
13
2.3RS‐485andControllerConnection
TypicalConnection:

Figure2‐5 Contr ollerConnectionA
ToconnectPTZtotheDVR:
Step1 DisconnectpluggableblockfromtheRS‐485terminalblock.
Step2 Pressandholdtheorangepartofthepluggableblock;insertsignalcablesinto
slotsandreleasetheorangepart.Ensuresignalcablesareintight.
Step3 ConnectA+onPTZtoD+onterminalblockandB‐oncontrollertoD‐onterminal
block.Fastenstopscrews.
Step4 Connectpluggableblockbackintoterminalblock.

MakesureboththecontrollerandDVRaregrounded.