LTS 83 K-ET Series - Chapter 2 Installation and Connections; DVR Installation; Hard Disk Installation

DigitalVideoRecorderQuickStartGuide
10
Chapter2InstallationandConnections
2.1DVRInstallation
DuringinstallationoftheDVR:
 Usebracketsforrackmounting.
 Ensureampleroomforaudioandvideocables.
 Whenroutingcables,ensurethatthebendradiusofthecablesarenolessthan
fivetimesthanitsdiameter.
 Connectthealarmcable.
 Allowatleast2cm(≈0.75‐inch)ofspacebetweenracksmounteddevices.
 EnsuretheDVRisgrounded.
 Environmentaltemperatureshouldbewithintherangeof‐10to+55ºC,+14to
+131ºF.
 Environmentalhumidityshouldbewithintherangeof10%to90%.
2.2HardDiskInstallation
Beforeyoustart
Beforeinstallingaharddiskdrive(HDD),pleasemakesurethepowerisdisconnected
fromtheDVR.AfactoryrecommendedHDDshouldbeusedforthisinstallation.
OneortwoSATAharddiskscanbeinstalleddependingondifferentmodels.
ToolsRequired:Screwdriver.

AstheinstallationstepsofHDDaresimilaramongdifferentmodels,herewejusttake
anexample.
Step1 RemovethecoverfromtheDVRbyunfasteningthescrewsonthebackandside.