LTS LTH-D301GY-WIFI-2 - Set Linked Device IP

Two-Wire Indoor Station Configuration Guide
6
2. Enable DHCP, then the indoor station can search and get an IP address automatically.
Note
Skip the following steps if you have enabled DHCP.
3. Set the IP address manually.
4. Tap to select the NIC Type.
2.3.2 Set Linked Device IP
Linked network parameters refers to the network parameters of devices (like door station,
doorphone, master station, center, etc.), to which the indoor station is linked. Linked devices for
the indoor station refers to door station, center, master station, and doorphone.
With the private SIP protocol, intercom can be realized only when all these devices are in the same
network segment with the indoor station.
With the standard SIP protocol, intercom can be realized when all these devices support the
standard SIP protocol.
Steps
Note
● The doorphone does not support adding with the standard SIP protocol.
● Here take door station network settings as example.
1. Tap Settings → → Configuration → to enter the device management page.
Note
Default admin password is the activation password.