LTS LTH-D301GY-WIFI-2 - Configuration Settings; Set Indoor Station Network Parameters

Two-Wire Indoor Station Configuration Guide
5
5) Tap OK to save the settings.
5. Tap Finish to save the settings.
2.3 Configuration Settings
Configuration settings is required before starting using the indoor station. It is necessary to set the
indoor station network, room No., linked devices, device time display, and so on.
2.3.1 Set Indoor Station Network Parameters
Network connection is mandatory for the use of the indoor station. Set the network parameters
after activating the indoor station. Only when the IP address of the indoor station is in the same
network segment as other devices, it can work properly in the same system.
Steps
Note
The default IP address of the indoor station is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1. Tap Settings → → Configuration → to enter the network settings page.
Note
Enter activate password as the admin password.
Figure 2-6 Network Settings