MERLIN LEGEND Communications System Release 6.1
Pocket Reference
555-661-116
Issue 1
August 1998
Page 14
Release 4.1 Enhancements (June, 1997)
■ Maintenance Enhancements
— Change to Permanent Error Alarm
Beginning with Release 4.2, the most recent permanent error
alarm is not shown on the System Error Log menu screen but
is available as an option from that screen. For details, refer to
the Maintenance section of the technician guide, Installation,
Programming and Maintenance.
— Enhanced Extension Information Report
Beginning with Release 4.2, the Extension Information
Report includes the Extension Status (ESS) and supervisory
mode for each extension.
Release 4.1 Enhancements (June, 1997)
Release 4.1 includes all Release 4.0 functionality plus the
enhancements listed below. There are no hardware changes in
Release 4.1.
■ Coverage Timers Programmed for Individual Extensions
Beginning with Release 4.1, coverage timers, which control the
duration of the delay before calls are sent to each level of
coverage, are changed as follows:
— The Group Coverage Ring Delay (1-9 rings) is programmed
on individual extensions and replaces the Coverage Delay
Interval programmed systemwide in previous releases.
— The Primary Cover Ring Delay (1-6 rings) and Secondary
Cover Ring Delay (1-6 rings) programmed on individual
extensions replace the Delay Ring Interval programmed
systemwide in previous releases.
These enhancements allow the system manager to customize
coverage call delivery to match individual extensions’ call-
handling requirements.
■ Night Service Coverage Control
Beginning with Release 4.1, a system manager can enable the
Night Service Coverage Control option to automatically control
the status of telephones programmed with Coverage VMS
(Voice Mail System) Off buttons according to Night Service
status.
When Coverage Control is enabled and the MERLIN LEGEND
Communications System is put into Night Service, all
programmed Coverage VMS Off buttons are automatically
turned off (LED is off) and all eligible outside calls are sent to
the assigned voice messaging system calling group with normal
ringing delay. When Night Service is deactivated during the day,
all programmed Coverage VMS Off buttons are automatically
turned on (LED is on) and voice mail coverage is disabled for
outside calls.
Users can override the Coverage VMS Off button status at any
time by pressing the programmed Coverage VMS Off button to
turn the LED on or off.
■ Night Service Group Line Assignment
Beginning with Release 4.1, a system manager can assign lines
to Night Service groups to control handling of after-hours calls
received on individual lines. This capability replaces the
To Next Page
Loading...
Need help?
General
