Lucent Technologies MERLIN LEGEND Release 6.1 Pocket Reference

MERLIN LEGEND Communications System Release 6.1
Pocket Reference
555-661-116
Issue 1
August 1998
Page 150
Technical Addendum
Installing SPM
Follow these steps to install System Programming and
Maintenance (SPM) onto the hard drive of a computer:
1. Insert the SPM disk into the computer.
2. At the C: prompt, type
MKDIR SPM and press ENTER.
3. Type
cd\spm and press ENTER.
4. Type
a:install and press ENTER to install the program from the
disk.
5. After the installation is complete, type
spm and press ENTER to
display the SPM Welcome screen.
Accessing SPM
Direct Local Connection
Follow these steps to access SPM when you are directly connected
to the system via the administration jack on the processor module:
1. Set up the physical connection between your laptop or PC and
the control unit.
2. Type
spm and press ENTER to display the SPM Welcome
screen.
3. Press any key to display the SPM Main Menu.
Local Modem Connection
Follow these steps to access SPM when you are connected onsite
via a modem:
1. Set up the physical connections between the PC and an
012 T/R module on the control unit.
2. Type
spm and press ENTER to display the SPM Welcome
screen.
3. Press ENTER to display a blank screen on which you can enter
modem commands. (You may have to press ENTER several
times.)
4. Dial
$7'7 .
5. Type the SPM password to display the SPM Main Menu.
Technical Addendum

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English