Lucent Technologies PARTNER Advanced Communications System - Page 23

Installation Procedures
17
3 a. Verify that the PARTNER ACS
processor module is in the
center slot of the carrier. In the
other slots, from left to right,
first install the 308EC or 206
modules followed by the 400 or
200 modules.
b. Align the module carefully in
the appropriate slot. For proper
engagement of the connectors,
the module must be inserted
straight into the carrier. Once
the module is properly seated,
firmly push the center of the
module until the connectors on
the module lock into place, and
the module is attached to the
rear of the carrier. A slight click
indicates the connectors are
engaged.
!
CAUTION:
Do not force the
module. Use the
carrier shelf as a
reference and do
not tilt, slant or
rotate the module.
If the module does
not insert easily,
remove it, clear any
obstruction, and
reinsert it.
PARTNER
3000
Carrier Shelf
YES
Carrier Shelf
NO