Lucent Technologies PARTNER Advanced Communications System - Initializing the System

Installation Procedures
23
Initializing the System
NOTE:
The system must be powered down before you insert or remove a PC Card.
The Backup/Restore, Automatic System Answer/Direct Extension Dial, PARTNER
VOICE MESSAGING Basics, and software upgrade features of the system all
require the use of a PC Card. If you plan to use any of these features, insert the
appropriate PC Card in a PC Card Slot before applying power to the system. See
“Inserting or Removing a PC Card” later in this guide.
NOTE:
ACS Release 3.0 includes a PARTNER Remote Access PC Card, which
allows the user to administer the system remotely
1
and perform backup and
restore functions. The PARTNER Remote Access PC Card can also be
used to upgrade previous versions of PARTNER ACS to Release 3.0.
Before you can use PARTNER VOICE MESSAGING, the PARTNER ACS must
be upgraded from Release 1.0 to Release 1.1 or later. PARTNER VOICE
MESSAGING does not work with ACS Release 1.0.
To apply the PARTNER ACS to a Release 1.1 or Release 2.0 or later software
upgrade, use the following procedure:
1 Insert the PC Card in the PC Card
Slot before powering up the
system for the first time.
!
WARNING:
!
All other PC Cards must be
removed from the processor
before initiating an upgrade.
2 Power up the system as described
in the following procedure. While
the system upgrades, the bicolor
(red/green) power LED on the processor flashes green and red alternately.
When the upgrade has finished (in about 20 seconds), the power LED
becomes steady green.
3 Power down the system.
1. Additional PARTNER Remote PC-Software required.
PFT
MODULE
R3.0
206
PFT
E
X
T
E
N
S
I
O
N
S
L
I
N
E
S
PFT
PFT
L
I
N
E
S
E
X
T
E
N
S
I
O
N
S
MODULE
R3.0
206
PARTNER
3000
PFT
L
I
N
E
S
E
X
T
E
N
S
I
O
N
S
PFT
MODULE
R3.0
400
PFT
L
I
N
E
S
E
X
T
E
N
S
I
O
N
S
PFT
MODULE
R3.0
400
5-Slot Carrier
On/Off Switch
Power
Jack