Equipment Upgrades
47
Inserting or Removing a PC Card
!
CAUTION:
Before starting, verify that you have batteries installed in the PARTNER
ACS processor module.
1 If you have an existing 5-Slot
Carrier, move the carrier’s On/Off
switch to the “Off” position (“O”).
For all types of installations,
disconnect the power cord from
the power jack. For illustrations
showing the location of the power
jack on the various configurations,
see “Initializing the System”
earlier in this guide.
2 If you do not have a 5-Slot Carrier, go to Step 3. If you have a 5-Slot Carrier:
a. Loosen the screw on the lower front of the cover. Then place one hand on
the handle on the bottom front of the cover and place your other hand on
the top of the cover.
b. Gently pull the cover up and away from the carrier. Be careful not to break
the tabs that attach the cover to the carrier.
3 Insert the PC Card in the PC Card
slot on the PARTNER ACS
processor module. When inserted
properly, the PC Card projects about
1-5/8” (4 cm) from the module.
4 Power up the system:
a. Reconnect the power cord.
!
CAUTION:
The power cord should hang straight down from the connector, flush against
the plastic case for the entire length of the board. Do not install the power
cord at an angle to the case or with a loop in it.
b. If you have a 5-Slot Carrier, move the carrier’s On/Off switch to the “On”
position (“—”).
PFT
PFT
E
X
T
E
N
S
I
O
N
S
L
I
N
E
S
MODULE
206
PFT
L
I
N
E
S
MODULE
206
PARTNER
3000
To Next Page
Loading...
