Lucent Technologies PARTNER Advanced Communications System - Connecting a PARTNER-CA48; Intercom Autodialer

Installation Procedures
35
1 Insert an RCA phono plug into the
Music-On-Hold jack on the
PARTNER ACS processor
module (located near the middle
of the processor, below the line
jacks).
2 Route the cord as you did for line
and extension cords, then connect
the other end of the cord to the
audio source.
3 Place a call on hold and listen. If you do not hear music at any setting, refer to
Music-On-Hold (#602) and Music-On-Hold Volume (#614) in Chapter 5 of
the
PARTNER Advanced Communications System Programming and Use
guide.
Connecting a PARTNER-CA48
Intercom Autodialer
The PARTNER-CA48 Intercom Autodialer is shipped with an adapter, a D8W line
cord, a power cord, a power unit, and a button-labeling sheet.
NOTE:
The PARTNER-CA48 Intercom Autodialer can be wall-mounted to work next
to a wall-mounted system phone. See the instructions provided with the
Autodialer.
1 Plug the adapter into the wall jack.
2 a. Plug one end of the D8W line
cord into the J1 jack on the
adapter.
b. Plug the other end of the D8W
line cord into the IN jack on the
bottom of the Autodialer.
COMBO
COMBO
-
-
Feature
Intercom
ABC
2
DEF
31
+
–
Conf
JKL
5
MNO
6
TUV
8
WXYZ
9
Transfr
Mic
HFAI
Hold
0
GHI
4
PQRS
7
*
#
Spkr
Intercom
Message
Ext.