Equipment Upgrades
37
Equipment Upgrades
Replacing System Modules
The procedure for replacing a module depends on your configuration:
Replacing a Stand-Alone PARTNER ACS Processor
Module
!
WARNING:
!
Disconnect the power cord from the power jack on the PARTNER ACS
processor module. For an illustration showing the location of the power jack,
see
“Initializing the System”
earlier in this guide.
1 Check the slack in the wires. If
there is not enough slack to
remove the module without pulling
the line and extension cords free,
label and disconnect the wires
before continuing.
2 Remove the screws at the top and
bottom of the module, and remove
the module from the wall.
3 Follow the instructions in
“Wall-Mounting a Stand-Alone
PARTNER ACS Processor
Module” and “Inserting
Batteries in the PARTNER ACS
Processor Module”earlier in this
guide.
If you have a...
See...
Stand-alone PARTNER ACS
processor module configuration
“Replacing a Stand-Alone PARTNER ACS
Processor Module”
2-Slot carrier configuration “Replacing Modules in a 2-Slot Carrier”
5-Slot carrier configuration “Replacing Modules in a 5-Slot Carrier”
C
O
M
B
O
C
O
M
B
O
To Next Page
Loading...
