Equipment Upgrades
39
Replacing Modules in a 2-Slot Carrier
!
WARNING:
!
Before starting, verify that you have batteries installed in the PARTNER ACS
processor module, and then disconnect the power cord from the power jack on
the carrier. For an illustration showing the location of the power jack, see
“Initializing the System”
earlier in this guide.
1 Check the slack in the wires. If
there is not enough slack to
remove the modules without
pulling the line and extension
cords free, label and disconnect
the wires before continuing.
2 Remove the long screw at the
bottom of the modules.
3 Remove the screws that attach
the carrier to the modules.
To Next Page
Loading...
