Lucent Technologies PARTNER Advanced Communications System - Connecting Contact Closure, Call Reporting (SMDR), Paging, and Music-On-Hold Devices

Installation
32
Connecting and Testing Telephones
Use the following procedure to connect and test a phone:
1 To connect a phone, plug the
modular telephone mounting cord
into a modular wall jack or directly
into a module extension jack. (If
you are connecting a standard
phone and its mounting cord is
loose, try a Lucent Technologies
D2R mounting cord instead.)
To install two phones (or other
devices) on a single extension
jack, see “Combination
Extensions” earlier in this guide.
2 Test the telephone for proper
operation. To test the power and
lights on a system phone:
a. While the phone is idle, press
and hold the
# button for five
seconds.
b. Before releasing the
# button,
lift the handset. All lights
should light, the ringer should
sound, and (on system display
phones only) a test pattern
should appear on the display.
(If not, call for support as
instructed on the inside front
cover of this guide.)
c. Replace the handset; the
phone is now in normal
operating mode.
Connecting Contact Closure, Call Reporting (SMDR),
Paging, and Music-On-Hold Devices
Only steps for connection to the PARTNER ACS processor module are provided
here. See the manufacturer’s instructions for more information about installing
and using these devices.
L
I
N
E
S
PFT
E
X
T
E
N
S
I
O
N
S
PFT
4
5
23
18
19
20
21
22
MODULE
206
L
I
N
E
S
PFT
E
X
T
E
N
S
I
O
N
S
PFT
6
7
24
25
26
27
28
29
MODULE
206
Transfr
Feature
Intercom
ABC
2
DEF
31
+
–
Conf
JKL
5
MNO
6
TUV
8
WXYZ
9
Mic
HFAI
Hold
0
GHI
4
PQRS
7
*
#
Spkr
Intercom
Ext.
Message
1
2
3
10
11
12
14
15
16
17
13