Installation Procedures
33
Contact Closure Adjunct
Use the following procedure to connect the Contact Closure:
1 Insert the modular plug into the
Contact Closure jack, the first jack
on the PARTNER ACS processor
module.
2 Route the cord as you did for the
line and extension cords, then
connect the other end of the cord
to the jack in the Contact Closure
Adjunct.
3
Have a qualified electrician wire
the Contact Closure device or
devices to the wiring receptacles in
the other end of the Contact Closure
Adjunct. See the information shipped
with the Contact Closure Adjunct for
wiring instructions.
Call Reporting (SMDR) Printer
Use the following procedure to connect the Call Reporting Printer:
1 Insert one end of a D8W modular
cord into the SMDR jack, the second
jack on the PARTNER ACS processor
module.
2 Plug the other end of the cord into a
355A adapter, then plug the adapter
into the printer’s RS-232C serial port.
PARTNER 3000
Contact Closure Adjunct
To Next Page
Loading...
