Installation Procedures
31
NOTE:
It is possible, with selected phone models, to wall-mount the phone in a
manner that allows you to retain full functionality of the slide tray and tray
card. Use one of the following procedures to accomplish this:
■ If you have an 18/18D, 34D, or DSS phone, the tray can be removed
from the “desk” end of the stand and inserted into the “wall” end. If a
630B wall plate is used, the tray will hang down from the phone.
■ If you do
not
use the 630B wall plate with the 18/18D and 34D phones,
the tray can slide under the set. To accomplish this, there are two
mounting holes on the left and right sides of the stand that will allow the
tray to slide underneath.
4 a. To mount the phone on the
stand, insert the tabs on the
top of the stand into the
middle
set of notches on the top edge
of the phone.
b. Make sure the telephone cord
is neatly wrapped inside the
phone, then rotate the phone
down until the bottom edge
snaps into position.
5 a. Remove the plastic cover from
the phone. Label the button
sheet to show any
programmed lines or button
features, then place the button
sheet on the phone so the
holes fit over the buttons.
Carefully replace the plastic
cover.
b. Make sure the swivel display is
set to the lowest position.
To Next Page
Loading...
