Installation
30
Wall-Mounting
Wall-mounting instructions apply only to PARTNER-model phones. For all other
system phones, follow the instructions provided with the phone.
Use the following procedure to wall-mount a phone:
1 a. Reverse the plastic hook that
sits in the earpiece part of the
handset cradle.
b. Turn the phone upside down
and remove the tray that holds
the
User Instruction
cards:
press the tabs on both sides of
the tray near the pull out tab
while sliding the tray straight
out.
2 Holding the stand with the wide
edge down, mount the stand on
the wall plate using the keyholes
on the base of the stand. For
proper mounting, the wall plate
must be a Lucent Technologies
630B connecting block.
3 a. Plug one end of the telephone
cord into the jack in the center
of the wall plate.
b. Plug the other end of the
telephone cord into the LINE
jack on the bottom of the
telephone.
c. Wrap any excess cord around
the cord wrap posts on the
bottom inside of the stand.
To Next Page
Loading...
