Lucent Technologies PARTNER Advanced Communications System - Page 54

Installation
48
5 Check that all green lights on the
fronts of the modules are lit:
a.
If a single light is out, power
down the control unit, reseat
the module, then power up the
control unit.
b.
If multiple lights are out, power
down the control unit, reseat
the leftmost module that has a
light out, then power up the
control unit.
c.
If the lights are still out , call for
support as instructed on the
inside front cover of this guide.
d. Power down and remove the
upgrade card.
6 a. If you have a 2-Slot Carrier or
a stand-alone configuration,
you are finished with this
procedure. If you have a 5-Slot
Carrier, continue with Step 5b.
b. Make sure all modules are
seated properly. The cover will
not fit if the modules are not
seated properly.
c. To replace the cover, grasp it
by its upper edges and hold it
squarely over the control unit.
d. Place the cover over the
modules and make sure it fits
firmly in place.
e. Tighten the screw on the lower
front of the cover.
L
I
N
E
S
PFT
L
I
N
E
S
PFT
Lights