Installation
24
4 Remove the PARTNER Remote Access PC Card.
NOTE:
For ACS Release 3.0., the PARTNER Remote Access PC Card is used to
upgrade the system. This card is also used for remote PC administration
and backup/restore and should not be removed or discarded.
5 Re-power the system.
To power up the system, use the following procedure:
1 a. If you have a stand-alone or a
2-Slot Carrier configuration,
skip to Step 1b. If you have a
5-Slot Carrier, move the
carrier’s On/Off switch to the
“Off” position (“O”).
b. Press the power cord firmly
into the power jack on the
carrier or stand-alone
PARTNER ACS processor
module until it locks into place.
(See the illustrations on this
page for the location of the
power jack for each type of
configuration.)
c. Plug the other end of the
power cord into a properly
grounded three-prong wall
outlet not controlled by a
switch.
!
CAUTION:
The power cord should hang
straight down from the
connector, flush against the
plastic case for the entire
length of the board. Do not
install the power cord at an
angle to the case or with a
loop in it.
d. If you have a 5-Slot Carrier, power up the control unit by moving the On/Off
switch to the “On” position (“—”).
To Next Page
Loading...
