Installation Procedures
21
3 Remove the battery assembly by
gently pulling the tab at the bottom
of the battery compartment cover.
4 Insert two new AAA-size standard
alkaline batteries into the metal
battery clips by pushing them
straight in, placing the negative
(–) end of one battery into the
bottom clip and the positive (+)
end of the other battery into the
top clip.
5 With the locking latch in the
unlocked position (battery icon
and “minus” icon visible), slide the
battery assembly into the
processor module along the
battery guides on the inside of the
battery compartment.
6 Make sure the battery assembly is
pushed in far enough that the
edges of the assembly slip behind
the plastic housing of the
processor module.
Tab
Push to
insert
Tab
Locking Latch
To Next Page
Loading...
