363-205-401 Conversions:
Issue 7, March 1997 Page 1 of 2
IXL-001
RT Channel Bank Conversions Task Index List
FIND YOUR JOB IN THE LIST BELOW .....THEN GO TO
Acceptance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .NTP-002
Convert Series 5 RT from Feature Package A Capability to
Feature Package C Capability . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .NTP-003
Convert Feature Package A or C RT to Feature Package C-AutoCut . . . . . .NTP-004
Convert Series 5 RT from Feature Package B Mode 2 to
Feature Package B Mode 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .NTP-005
Convert Series 5 RT from Feature Package B Mode 1 to
Feature Package B Mode 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .NTP-006
Add Special Service Capability to Feature Package B RT. . . . . . . . . . . . . . .NTP-007
Add or Remove Protection Line Option . . . . . . . . . . . . . . . . . . . . . . . . . . . . .NTP-008
Convert Series 5 RT to Any Feature Package Capability
Generic Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .NTP-009
Convert Feature Package B Mode 1 or Mode 2 to
Feature Package 303. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .NTP-010
Reinstate Feature Package B Following a Failed Conversion to
Feature Package 303. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .NTP-011
Verify That Correct Complement of Circuit Packs is Available . . . . . . . . . . . DLP-500
!
CAUTION:
In dusty areas (for example, near construction sites), Lucent
Technologies recommends tenting the RT cabinet to protect
electronic equipment whenever cabinet doors are open for
extended periods.
To Next Page
Loading...