EasyManuals Logo

LumaSense 320 Series User Manual

LumaSense 320 Series
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
IGA 320/23 Operating Manual Settings / parameter descriptions
21
4.15 Limit switch (SP1)
The pyrometer is equipped with a switch contact (opto relays; max. 50 V DC, 0.2 A; max. power
800 mW), controlled from the measuring signal. The contact is activated with:
Close above: The contact closes (switches to ground), if the temperature entered in the SP1
box is exceeded. If the temperature falls below that value minus the hysteresis the contact opens
(a hysteresis between 2 and 20 °C can be set to avoid oscillating of the switch in the switch
point).
Close below: The contact closes (switches to ground), if the temperature falls below the
entered value in the SP1 box. If the temperature exceeds that value plus the hysteresis the
contact opens (a hysteresis between 2 and 20 °C can be set to avoid oscillating of the switch in
the switch point).
4.16 Operating hours
Shows the operation time that the pyrometer has been in use.

Other manuals for LumaSense 320 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LumaSense 320 Series and is the answer not in the manual?

LumaSense 320 Series Specifications

General IconGeneral
BrandLumaSense
Model320 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals