Lumel N31U - Page 14

14
N31U User manual
will allow to enter the menu but it will be not possible to change the parameters
- parameters monitoring mode. Entering a correct password will allow to move
to a programming matrix, the menu after entering the programming mode is
shown below.
While navigating the meter main menu with the groups of the parameters, the
upper line of the display shows the name of the group and the lower line con-
tinuously displays the word MENU. After entering the group of the parameters
(after pressing the conrm button), the upper line displays the value of a given
setting and the lower line shows the name of the parameter which value is
displayed in the upper line. Sample view of the selection of the measured input
signal type is shown in Fig. 8.
The buttons allow to navigate the menu of the meter. After selec-
ting the group of the parameters which conguration is to be changed, press
the conrm button to move to the parameters of the group. The parameter
which value is to be modied is selected the same way as the selection of the
group. To cancel the parameter change, press the cancel button to
exit the parameter changing mode or the parameter group. The transducer will
automatically exit the programming mode and return to displaying the mea-
suring value if no button is pressed for 30 seconds during programming. The
programming matrix is shown below.
Fig. 7: View of meter menu.
Fig. 8: View of menu when setting a parameter.
Current value
of a setting
Parameter which can
be congured