Lumel N31U - Page 15

15
N31U User manual
Input type selection
(measuring signal
or sensor).
Standard avera-
ging - number of
the measurements
to be averaged..
Moving window
method averaging
- number of the
measurements
to be averaged
(window width).
Compensation
method selection -
important parame-
ter for temperature
measurement
sensors (thermore-
sistors and thermo-
couple sensors)
Compensation
value for manual
compensation
method of wires
resistance or termi-
nals temperature.
Mathematical
function selection
based on which
the measuring
value should
be converted.
Enabling or
disabling the indivi-
dual characteristic.
Number of points
of the individu-
al characteristic.
Measuring value -
point no. 1.
Expected value
for the measuring
value X1.
Measuring value -
point no. 2.
Expected value
for the measuring
value X2.
... ... Measuring value -
point no. 32.
Expected value
for the measuring
value X32.
Selection of main
displayed value.
Minimum value on
the display. For
values lower than
this value, a lower
overrun message
is displayed.
Maximum value
on the display.
For values
higher than this
value, an upper
overrun message
is displayed.
Resolution -
position of the
decimal point.
The unit which can
be displayed in the
lower line (when
displaying the
measuring value).
Function of a lower
line of the display
- selection of a
quantity displayed
in the lower line .