Need help?Do you have a question about the Lumel P20 and is the answer not in the manual?
General| Brand | Lumel |
|---|---|
| Model | P20 |
| Category | Transducer |
| Language | English |
Key safety observations regarding transport, installation, commissioning, and maintenance must be followed.
Details the mounting method for P20 transducers on a 35 mm rail according to EN 60715 standards.
Illustrates various wiring configurations for RTD, TC, voltage, and current inputs.
Guides on connecting and configuring the P20 transducer using the eCon software and PD14 programmer.
Explains how to select the input type, measuring range, and averaging time via the eCon software.
Details configuring the linear characteristic of the analog output using two points (X1 In, Y1 Out) and (X2 In, Y2 Out).
Allows configuring how the analog output behaves during signal overflow conditions on the measuring input.
Describes how to read the currently measured value and output type using the 'Measured values' window.
Explains where to find the serial number and software version in the eCon configuration panel.
To Next Page
