Why ONVIF software cannot locate my Lumens VC-A71PN Camcorder?
If ONVIF software cannot locate your Lumens Camcorder, it may be due to special characters or spaces in the camera's location settings. Ensure that you only use English alphabets or numbers in the [Setting]>[Video]> [Camera](Location) section of the webpage.
What to do if Lumens VC-A71PN Camcorder does not save parameters after reboot?
If your Lumens Camcorder doesn't save parameters like PTZ or AWB after a reboot, make sure the Initial Position is set to Last Operated Position in the setting menu or web page.
How to enable Tally lamp on Lumens VC-A71PN Camcorder with RS232 setting?
If the tally lamp on your Lumens Camcorder isn't working with RS232 settings, verify that the Tally lamp function is enabled in the setting menu or web page.
General| Image Sensor | 1/2.8" CMOS |
|---|---|
| Optical Zoom | 20x |
| Digital Zoom | 12x |
| Audio Output | 3.5 mm Line out |
| Power | DC 12V |
| Camera Type | PTZ Camera |
| Focal Length | f=4.7mm~94mm |
| Aperture | F1.6 to F3.5 |
| Shutter Speed | 1/1 to 1/10000 sec |
| Video Output | HDMI |
| Video Format | H.264 |
| Audio Input | 3.5mm Mic In |
| Control Interface | RS-232 |
| IP Streaming | RTSP |
To Next Page
