LUMINELL SL1 - Operator Panel Technical Data

4 Technical Data
LUMINELL SWEDEN AB 14
4.2 OPERATOR PANEL
Technical Data Operator Panel
Input
Nominal voltage
24VDC (20...28VDC)
Power consumption in operation
Max 10W
Power consumption in standby
mode (parked, light off)
2,2W
Current at 24V
Max 0,4A
Installation
Electrical interface to vessel
- DC power 3 wires (+/-/earth) (see drawing in manual for details)
- Ethernet to operator control panel or switch (if any)
Mechanical interface to vessel
- 3 x threaded rod M4 in panel base
- Sealing between console and panel
Start-up
System boot time
(from power off)
≈30 sec (searchlight homing procedure)
Environmental
Operating ambient temperature
-25ºC to +55ºC (-13°F to 131°F)
Storage temperature
-25°C to +70°C (-13°F to +158°F)
IP class
IP56
Vibration
IEC 60945
Shock
IEC 60945
Dimensions & weight
Static size
19 x 40 x 42 cm (see drawing in manual for details)
Weight
0,5kg
Materials & Colors
Body / casing
Operator panel made in PC-ABS
Base, bolts
Stainless steel AISI 316L (1.4404), A4
Functions
Direct button functions
- Horizontal and vertical movement
- Light on/off
- Wave compensation on/off (firmware update might be required,
contact Luminell)
- Beam angle spot/flood
- Dimming step by step
Standard menu functions
- Custom home screen – set your 4 most used functions
- Up to 4 programmable fixed positions
- Sweep in horizontal direction
- Surveillance in horizontal and vertical direction
- Switch – to another potential SL1 in the network
- Sync