Lust CDD34.005-HF - Motor Temperature Monitoring

CDD3000-HF Operation Manual
3-7
3 Installation
DE
EN
FR
IT
ES
FR
1
2
3
4
5
A
3.3.2 Motor
temperature
monitoring
Figure 3.3 Connection of the temperature sensor
For thermal monitoring of the motor winding, the temperature sensors
specified in Table 3.1 can be connected to terminals X3 / ϑ- and ϑ+.
Attention: Contrary to DIN VDE 0660-303 (short circuit dedection
<20Ω) the CDD3000-HF will note a short circuit at < 50 Ω.
For commissioning the correct type of temperature sensor used in the
connected motor must be set up. This measure is not necessary if a
matching motor data set is available.
Sensor
Tech. data
No PTC
used
Standard
PTC
Linear
voltage evaluation
TSS,
thermostatic
circuit-breaker
Usable type -
PTC based on
DIN44082
KTY84, yellow Klixon
Parameters
330-MOPTC =
OFF DIN KTY TSS
Measurement
voltage U
MAX
–12 V –
Table 3.1 Motor temperature monitoring specification
X3
M
3~
1
V
2
U
W