4)After select the upper text to " yES " or " no ", press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting
function with default.
5)The procedures to execute the Loop time record
function :
a. For the above point 4) should select " yES "
b.Press the " REC Button " ( 3-4, Fig. 1 ) the " REC "
symbol will show on the Display.
c. Now the meter will ready for recoding the data
within the Loop time period, start to recod
from the " Start time " and end to record on the
" End time " .
d.Pause the Loop record function :
During the Loop time. meter already execute the
record function, if press the " Logger Button " ( 3-7,
Fig. 1 ) once will pause the Datalogger function (
stop to save the measuring data into the memory
circuit temporally ). In the same time the text of
" REC " will stop flashing.
Remark :
If press the " Logger Button " ( 3-7, Fig. 1 ) once
again will execute the Datalogger again, the text of
" REC " will flashing.
Finish the Loop Datalogger :
During pause the Datalogger, press the " REC
Button " ( 3-4, Fig. 1) continuously at least two
seconds, the " REC " indicator will be disappeared
and finish the Datalogger.
e.Screen text description for the Loop Datalogger :
StAr = Start
-t- = Time
End = End
18
To Next Page
Loading...
