3)Rotate the Sensing Head is prohibited. Some certain
angles between Sensing Head & measuring object
are not allowed ( ref. Fig. 3 ).
Fig. 3
4-2 Normal Measurement
1)Slide the " Power Off/On/Peak Hold Switch " ( 3-8, Fig. 1 )
to the " On " position.
0 = Off, 1 = On
2)Determine display unit of g, oz or Newton by selecting
" Kg/Newton/LB Unit Switch " ( 3-7, Fig. 1 ).
3)Connect " Sensing Head " ( 3-1, Fig. 1 ) with proper "
Adapter " ( 3-11 to 3-14, Fig. 1 ) and the " Measuring
Object " should be in straight line. Don't give any force in
standby mode..
4)" Zero Adjust " by pushing " Zero Button "
( 3-6, Fig. 1 ) before every measurement.
5)Start measurement by giving force (push or pull), then the
LCD will display the Average reading value.
During the measurement, if intend to change
the display direction, just push the " Reverse
Button " ( 3-5, Fig. 1 ) once.
6
To Next Page
Loading...
