Luvion ESSENTIAL CONNECT - Getting Started

7
LUVION Premium Baby products
• Keep the cords out of reach of children.
• Do not cover the Baby Monitor with a towel or blanket.
• Test this monitor and all its functions so that you are familiar with it prior to actual use.
• Do not use the Baby Monitor in damp areas or close to water.
• Do not install the Baby Monitor in extreme cold or heat, direct sunlight, or close to a heat source.
• Only use the chargers and power adaptors provided. Do not use other chargers or power adaptors
as this may damage the device and battery pack.
• Only insert a battery pack of the same type.
• Do not touch the plug contacts with sharp or metal objects.
• Connect the power adaptors to easily accessible electrical sockets.
• Read and keep the instructions. All the safety and operating instructions should be read before use.
• This device is designed for indoor use only.
• Don’t use the units if the cord or plug is damaged.
• Don’t attempt to repair or adjust any of the electrical or mechanical functions of the unit. If you do,
the guarantee will be made void.
WARNING:
There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries
according to their instructions. To reduce risk of re or burns.
• Do not attempt to disassemble, or service the battery pack.
• Do not crush, puncture, short external contacts, or dispose of in re or water.
• Do not heat above 60
°C (140°F).
• Use specic charger only.
• Replace only with the battery pack designated for this product.
2. GETTING STARTED
2.1 Connecting the power supply for the Camera (Baby Unit)
• Insert the DC plug of the power adaptor into the DC socket on the back of the Baby Unit.
• Connect the other end of the power adaptor to mains power.
• The Green power indicator lights when the baby unit is on.
Note:
Only use the power adaptor (5VDC, 1000mA) provided.