- 22 -
Fig 5.)(Integrated Peripherals/Onboard Device) Turn on full USB
mouse & keyboard control.
Fig 6.)( Integrated Peripherals/SuperIO Device) LUVOX AIO
systems are most frequently used as panel mount devices leaving
the power switch out of reach. Therefore ‘PWRON After PWR-Fail’
is set to [On] (This will make the device powering on each time
DC power returns after being removed)
- 23 -
Storage setups
The Hard disk / Storage configuration of a LUVOX AIO device is
available in 4 setups.
1. 80GB Internal Hard Disk Drive (IDE)
2. 4GB Internal Flash Drive (Single Internal TrueIDE mode
Compact Flash socket & 4GB industrial grade TrueIDE mode
UDMA CF Card included) No
Hard Disk Drive
3. Double External TrueIDE mode CF socket (CF Cards not
included), No
Hard Disk Drive
4. 80GB Internal Hard Disk Drive (IDE) and Double External
TrueIDE mode CF socket (CF Cards not
included).
Although it is proven possible to install and run a standard
Microsoft Windows XP PRO installation from a TrueIDE
mode UDMA CF card setup, LUVOX AIO Systems can only
be ordered with Windows XP PRO in setup 1 and 4.
When it is required to run a Microsoft Windows XP environment
from a TrueIDE mode CF Card, it is strongly advised to use the
componentized version Microsoft Windows XP Embedded.
With the Windows XP Embedded Enhanced Write Filter (EWF), it
is possible to protect the system at volume level and redirect all
disk writes to a protected drive in the system’s memory. This will
prevent the CF card from an instant wear out.
LUVOX AIO System are not offered with Windows XP Embedded,
although DOBIT NV, as the constructor, can assist customers in
building a custom Windows XP Embedded footprint for LUVOX AIO
Systems on project basis.
This way of custom and project based OS building assistance can
also be offered for a LINUX platform.
Please, contact our sales department for more information.
To Next Page
Loading...