Need help?Do you have a question about the Luxman C-120A and is the answer not in the manual?
General| Type | Preamplifier |
|---|---|
| Signal-to-Noise Ratio (line) | 100dB |
| Input Sensitivity (MM) | 2.5mV |
| Input Sensitivity (line) | 150mV |
| Output (line) | 150mV |
| Output (pre out) | 1V |
| Total Harmonic Distortion (THD) | 0.005% |
| Input Impedance (MM) | 47k ohms |
| Signal-to-Noise Ratio (MM) | 80dB |
| Frequency Response | 10Hz - 100kHz (±0.5dB) |
Visual identification of front panel controls and connectors.
Visual identification of rear panel connections and ports.
To Next Page
