Luxman L-505uX - Speaker Terminals

9
NTEGRATED AMPL FIER L-505uX
5. Pre-out terminal (PRE OUT)
This terminal is used to obtain the output of the
preamplier.
A bi
-amp connection can be performed with a
combination of an external power amplier because
this terminal always provides output regardless of the
separate switch setting.
Do not insert shortpin plugs into PRE OUT.
No sound is generated.
6. Main in terminal (MAIN IN)
Provides input to the main-amplier section when the
pre-amplifier and main-amplifier are separated by
setting the separate switch to on.
7. Balance input terminals (BAL LINE)
Are the balance type input terminals of the LINE level
for the XLR connector (cannon connector).
8. Phase inverters (PHASE)
Change the phase when the balance input terminal is
used. The phase shall be corresponding to the phase
of the input device.
9. AC inlet (AC IN)
Connects the accessory power cable. The power
shall be supplied from a household wall socket.
10.Speaker terminals (SPEAKERS)
Connects a speaker system.
The right speaker terminal shall be connected to
the R side, and the left speaker terminal shall be
connected to the L side in consideration of the
polarity.
Normal position
Invert position
1
GROUND
2
COLD
3
HOT
1
GROUND
2
HOT
3
COLD
General type terminal
* It is possible
to insert cables from below as well
as from above.