17
INTEGRATED AMPLIFIER L-507uX
MARKⅡ
Procedure of timer-controlled recording
1. Turn on the operation switch to activate this unit.
2. Select a source to be recorded under timer control with
the input selector.
3. Set the recording switch to on.
4. Perform time setting for start and stop times with your
timer.
5. Refer to the operating instructions of the timer and other
connected devices for further information.
If the volume control is not set to low levels, the source se-
lected with the input selector may be reproduced from the
speakers. Be sure to set the volume control to a low level.
When timer-controlled recording is performed, operations
of the amplifier are the same as regular use.
Procedure of timer-controlled playing
1. Turn on the operation switch to activate this unit.
2. Select a source to be reproduced under timer control
with the input selector.
3. Adjust the volume level with the volume control.
4. Perform time setting for start and stop times with your
timer.
5. Refer to the operating instructions of the timer and other
connected devices for further information.
Memory
This unit stores the following items when the power is off:
Item Default
INPUT Selected source
METER on/off
MONITOR on/off
SUBSONIC on/off
MONO on/off
LOUDNESS on/off
LINE STRAIGHT on/off
SEPARATE on/off
Memory reset
The following operations restore all the settings to the factory
defaults.
(1) Turn off the power of this unit.
(2) Hold down the operation switch on the main unit for 5
seconds or more and press the line straight switch on the
main unit once while holding down the operation switch,
and the power state switches from on to off.
That’s all for memory reset.
Factory default
Item Default
INPUT LINE-1
METER on
MONITOR off
SUBSONIC off
MONO off
LOUDNESS off
LINE STRAIGHT off
SEPARATE off
To Next Page
Loading...
Need help?
General
