Need help?Do you have a question about the Luxul AMS-1208P and is the answer not in the manual?
General| Ports | 8 |
|---|---|
| PoE+ Ports | 8 |
| Total PoE Budget | 120W |
| Switching Capacity | 16 Gbps |
| Forwarding Rate | 11.9 Mpps |
| MAC Address Table | 8K |
| Power Input | 100-240V AC, 50/60 Hz |
| VLAN Support | Yes |
| Managed | Yes |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Storage Temperature | -20 to 70°C (-4 to 158°F) |
| Humidity | 10% to 90% (non-condensing) |
| Dimensions | 280 x 180 x 44 mm (11.02 x 7.09 x 1.73 in) |
Covers rack-mounting and physical setup of the switch for optimal ventilation and stability.
Details connecting the switch to power and network devices using Ethernet cables.
Explains network cabling recommendations and IP addressing for switch access.
Guides on connecting a computer and logging into the switch's web interface for initial setup.
Describes the function of front panel LEDs for power, link activity, and system status.
Configuring system contact, name, and location for easy switch identification.
Guides on configuring the switch's IP address, DNS servers, and default gateway.
Manages IP interfaces, DHCP settings, and IP route configurations for network connectivity.
Configuring Network Time Protocol (NTP), system time, and Daylight Saving Time options.
Setting up Syslog server for log management, including server address and message levels.
Allows configuration of PoE settings, including port-specific power management and reservation modes.
Sets PoE mode, priority, and maximum power per port for connected devices.
Enables creation of 802.1Q VLANs and defines port access capabilities.
Sets port modes (Access, Trunk, Hybrid) and types for network segmentation.
Manages ingress filtering, acceptance, and egress tagging for VLAN traffic control.
Defines Private VLAN membership and allows adding/deleting port members.
Enables or disables port isolation within a VLAN to isolate ports from each other.
Configures STP protocol version, bridge priority, timers, and advanced port settings.
Sets up Multiple Spanning Tree Instances (MSTIs), maps VLANs, and configures instance priorities.
Configures CIST ports, including aggregated/normal settings, edge status, and security features.
Configures path cost and priority for individual MSTI ports.
To Next Page
