READ ME FIRST
Fold Fold Fold
QUICK INSTALL GUIDE
24-Port Gigabit Switch
AGS-1024
Includes:
One: AGS-1024 24-Port Gigabit Switch
Two: Rack-Mounting Ears
Four: Rubber Feet
One: Power Cable
SETUP AND CONFIGURATION
1
Physical Installation
The AGS-1024 can be rack-mounted or used as a desktop switch. Install the
AGS-1024 in a stable/safe place to avoid any possible damage. Avoid placement
in direct sunlight. Do not place heavy articles on the AGS-1024 and verify the
ground connection of the outlet is functioning properly.
Desktop/Shelf Installation
For desktop/shelf installation, attach the four rubber feet to the corner inden-
tations on the bottom of the AGS-1024, then place the switch horizontally on
a solid, level platform.
Rack Installation
Use the included L brackets for convenient installation in a 19-inch server or
audio/video rack. Use four screws to attach the L-shaped brackets on both
sides of the AGS-1024 as shown below, then install the switch horizontally in
the rack. Use your desired hardware to affix the switch brackets to the rack.
Attach Feet for Desktop Installation Install Brackets for Rack-Mounting
2
Connecting Ethernet and Power
Ethernet and Power Connections
Use any RJ-45 to connect the AGS-1024 to an Ethernet-enabled device,
including servers, routers or other switches. No crossover cable is necessary.
The AGS-1024 supports 10/100/1000 Mbps Ethernet; 10/100 Mbps half/
full-duplex mode and 1000 Mbps full-duplex mode.
Use the included power cable to connect the AGS-1024 to a surge protect-
ed outlet. The AC input socket and a power switch are on the rear panel.
The built-in power supply supports 100~240VAC at 50/60Hz.
c CAUTION: Use only the correct power cord for your environment.
Any voltage other than standard 100/240 will result in
damage to the AGS-1024.
LEGAL AND REGULATORY INFORMATION
No part of this publication, or any other publication may be modified or
adapted in any way, for any purposes without permission in writing from
Luxul. The material in this manual is subject to change without notice. Luxul
reserves the right to make changes to any product to improve reliability,
function, or design. No license is granted, either expressly or by implication
or otherwise under any Luxul intellectual property rights. An implied
license only exists for equipment, circuits and subsystems contained in this
or any Luxul product.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful inter-
ference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Hereby, Luxul, 14203 Minuteman Drive, Suite 201, Draper, Utah,
84020, declares that this Luxul AGS-1024 is in compliance with the
essential requirements and other relevant provisions of Directive
1995/5/EC.
For a copy of this report send a self addressed stamped envelope
to: Luxul CE, 14203 Minuteman Drive, Suite 201, Draper, Utah, 84020.
Industry Canada (RSS-Gen Issue 4)
CAN ICES-3(B)/NMB-3(B)
Sales
P: 801-822-5450
E: sales@luxul.com
Technical Support
P: 801-822-5450 Option 3
E: support@luxul.com
© 2015 Luxul. All Rights Reserved. LUX-QIG-AGS-1024 12221512
To Next Page
Need help?
General
