Chapter 5: Advanced Synthesizer and Effects Editing
54
Venom User Guide
Type Selects either a High-Pass or Low-Pass filter for the Auto Wah effect.
Cutoff Determines the initial cutoff frequency (20 Hz–16 kHz) of the filter.
Resonance Determines the resonance level (0–100) of the filter.
Sensitivity Sets the amount (–100 to +100%) that the triggered envelope modulates the filter cutoff frequency,
and is based on the amplitude of the input signal.
Attack Adjusts the attack time (2 ms–2 sec) of the triggered envelope.
Release Adjusts the release time (2 ms–2 sec) of the triggered envelope.
Distortion
Type Selects the type of distortion (Overdrive, Distortion, or Fuzz).
Depth Adjusts the input level (0–100%) or “drive” of the effect.
Pre Gain Adjusts the input level (0–100%) of the effect.
Post Gain Adjusts the output level (0–100%) of the effect.
High Cutoff Adjusts the corner frequency of a 24 dB low pass filter on the output of the effect.
Reducer
Bit-Depth Adjusts the Bit-Depth of the effect. Reducing the bit-depth increases the amount of square wave dis-
tortion applied to the audio signal.
Sample Rate Adjusts the sample rate (44.1 kHz–1.0 kHz) of the effect. Reducing the sample rate increases alias-
ing and the degradation of the audio signal.
Insert Effect, Distortion
Insert Effect, Reducer
To Next Page
Loading...
