M-Audio Venom

Chapter 5: Advanced Synthesizer and Effects Editing
55
Venom User Guide
Channel
The Channel controls provide output channel mixing controls for the currently selected Single Program.
These settings are useful for balancing the effects and the direct synth signal for the Single Program, as well
as providing output channel EQ.
Direct Sets the amount of dry (un-effected) signal for the currently selected Single Program.
Aux 1 Determines the level of Aux 1 processing for the currently selected Single Program. You can change the
send level to Aux 1 using the FX Send 1 Level knob on the top-panel Performance Control matrix (knob 3, row
6).
Aux 2 Determines the level of Aux 2 processing for the currently selected Single Program. You can change the
send level to Aux 2 using the FX Send 2 Level knob on the top-panel Performance Control matrix (knob 4, row
6).
Insert FX Type Selects the type of Insert effect for the channel output (see “Insert Effect” on page 53).
Pan Determines the panning location of the signal in the stereo field for the currently selected Single Program.
Volume Sets the overall output level for the currently selected Single Program.
Master
The Master section provides controls for master channel gain and EQ.
Master EQ
The Master EQ is applied on the main output after the Aux 1 and 2 Effects Returns and before the Main output.
Low Gain Boosts or attenuates (–12 dB to +12 dB) the low-shelf EQ below the corner frequency.
Low Freq Sets the corner frequency (20 Hz–1 kHz) of the low-shelf EQ.
Mid Gain Boosts or attenuates (–12 dB to +12 dB) the Mid EQ band.
Mid Freq Sets the center frequency (300 Hz–10 kHz) of the Mid EQ band.
High Gain Boosts or attenuates (–12 dB to +12 dB) the high-shelf EQ above the corner frequency.
High Freq Sets the corner frequency (500 Hz–10 kHz) of the high-shelf EQ.
Channel controls
Master controls