M-system 60C User Manual

9. WIRING & CONNECTIONS
9.1. POINTS OF CAUTION IN CONNECTING WIRES
Appropriate precautions are required such as follows for protecting the system from external noise interference:
1) Separate analog I/O and communication wires from others in order to prevent surge or induction noises.
2) Separate power input wires (AC) from those for driving motors.
3) Do not install these wires next to main supply circuits or high voltage cables.
Never bind them to these circuits.
4) Ground the shield of communication wires at one point.
Consideration about locations of the ground may be necessary according to external noise interference.
9.2. CONNECTOR PIN ASSIGNMENTS
■ INPUT CONNECTOR FOR 60C-x1
PIN NO. ASSIGNMENT PIN NO. ASSIGNMENT
1 Input 1 2 COM
3 Input 2 4 COM
5 Input 3 6 COM
7 Input 4 8 COM
9 Input 5 10 COM
11 Input 6 12 COM
13 Input 7 14 COM
15 Input 8 16 COM
17 Input 9 18 COM
19 Input 10 20 COM
21 Input 11 22 COM
23 Input 12 24 COM
25 Input 13 26 COM
27 Input 14 28 COM
29 Input 15 30 COM
31 Input 16 32 COM
33 No connection 34 No connection
Input 1 – 4 for 4 points, 1 – 8 for 8 points.
■ OUTPUT CONNECTOR FOR 60C-x2
PIN NO. ASSIGNMENT PIN NO. ASSIGNMENT
1 Output 1 2 COM
3 Output 2 4 COM
5 Output 3 6 COM
7 Output 4 8 COM
9 Output 5 10 COM
11 Output 6 12 COM
13 Output 7 14 COM
15 Output 8 16 COM
17 Output 9 18 COM
19 Output 10 20 COM
21 Output 11 22 COM
23 Output 12 24 COM
25 Output 13 26 COM
27 Output 14 28 COM
29 Output 15 30 COM
31 Output 16 32 COM
33 No connection 34 No connection
Output 1 – 4 for 4 points, 1 – 8 for 8 points.
60C
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
EM-6602 Rev.8 P. 8 / 13

M-system 60C Specifications

General

Brand	M-system
Model	60C
Category	I/O Systems
Language	English