8. O
2
Tank
These elements are described at the section 2.1.3.
2.1.2 Technical datas
Dimensions:
• Thickness: 16 cm
• Height: 50 cm
• Width: 45 cm
Weight:
• ready to dive: 12 kg
• empty: 7 kg
• Soda canister (axial cartridge): 2.2 kg
Gas Injection:
• O
2
: M3S valve (constant mass flow) 0.7 L/min in standard version
• Diluent: Injection by an ADV
2.1.3 The elements
The kevlar bag
All the components of the TRITON are contained inside a Kevlar bag of 35x30x16 cm. One
handle is fixed on rear of the bag in order to facilitate the carriage. Snap hooks are fixed on
the four corners of the bag in order to ensure a good fixing against the chest of the diver. A
stainless steel support is fixed at the bottom of the kevlar bag to carry on the oxygen tank.
During transport (travel), the breathing hoses, the gaz line and the electronic can be stored
into the kelvar bag with the lungs and the scrubber in order to be protected.
The oxygen tank
The oxygen tank must be used only for oxygen and must follow the certification standards.
It needs to be pressure tested every two years.
The regulator DS4
The regulator DS4 is a fixed intermediate pressure regulator. The standard setting is 11.5b.
(see section 2.1.3 CMF)
The control and the adjustment of the regulator must be done during the training.
Servicing has to be done following the constructor’s instruction manual.
4
To Next Page
Loading...