Changing Filter Cycle Duration
The duration of a lter cycle can be set in
hour increments of 2, 4, 6, 8, or continuous.
For example, a 2 hour cycle will complete once
every 12 hours for a total of 4 hours per day.
The amount of time needed to lter your spa
will depend on usage and ambient conditions.
You will need to program your lter cycles
based upon your personal use.
To change the duration of the lter cycles
touch the ‘TEMP’ pad and then touch the
‘JETS’ pad. Touch the ‘TEMP’ pad to adjust
the cycle duration to the desired setting. After
each press, the duration of the cycle will be
displayed in the LCD window as follows:
F2 2 Hours for each cycle, 4 hours per day
F4 4 Hours for each cycle, 8 hours per day
F6 6 Hours for each cycle, 12 hours per day
F8 8 hours for each cycle, 16 hours per day
FC Continuous ltration, 24 hours per day
To exit the lter-set procedure, touch ‘JETS’.
The LCD window will display the current water
temperature.
If a change is made to the duration while the
spa is in a ltration cycle, it will take eect
immediately. If the change is made outside a
ltration cycle, it will take eect at the start of
the next scheduled cycle.
NOTE: When power to the spa is denied
(disconnect, power outage), the controls
may revert to the default factory settings.
Any adjustments to set temperature
or lter cycle duration may need to be
reprogrammed.
To Next Page
Loading...
Need help?
General
