User’s Pads
User’s Pads are the buttons located on the
topside control panel and are used to program
various spa functions (i.e., turn on spa light, set
temperature, etc.). The following table denes
the pads:
Pad Use
• Increase temperature
• Change time settings
• Decrease temperature
• Change time settings
• Switch heating modes
• Turn internal spa light on
or o
• Optional. Turns blower
system on or o. Same as
Turbo
• Activate primary ltration
pump
• Activate therapy pump
Temperature Controls
The maximum set temperature is 104°F (40°C)
and the minimum set temperature is 80°F
(26°C). The current water temperature or, if the
pump has not been running, two dashes, will
show on the display. If dashes are displayed,
you must rst start the pump by pressing the
‘JETS 1’ pad. Wait until the water temperature
is displayed (approximately 2 minutes).
The set temperature of your spa may easily be
increased or decreased at any time using the
‘UP’ or ‘DOWN’ pads. When either of these
pads is touched, the set temperature will be
displayed in the LCD window. Each successive
touch will change the set temperature 1°F
(0.5°C) in the chosen direction. After 3 seconds
the LCD will automatically display the water
temperature or dash lines.
If the spa is set in Standard mode or in a
ltration cycle, adjusting the set temperature
may result in activating the heater. When
the heater is operating, the heat icon will be
displayed in the LCD.
Note: 230-Volt spas that are wired with the
low Amp option will not heat when Pump
1 is on in high speed, or when Pump 2 is in
operation.
JETS 1
Touch the ‘JETS 1’ pad to activate the primary
ltration pump. The sequence of the jet action is:
1 touch = Low jets
2 touches = High jets
3 touches = O
JETS 2
Touch the ‘JETS 2’ pad to activate the therapy
pump. The sequence of jet action is:
1 touch = High jets
2 touches = O
The low speed operation of Pump 1 is timed
to automatically turn o after 2 hours of
operation. The high speed operation of Pump 1
and the high speed operation of Pump 2,
are timed to automatically turn o after 15
minutes of operation.
To Next Page
Loading...
Need help?
General
