MAC3 HydroController HCW MT 1P - Page 72

User Guide HC - Copyright © 2008 MAC3. All right reserved.
Man 01
Disegno 6328
31
Via Baldanzese, 149 50041 Calenzano FI
Tel. 055 8877672 – Fax 8877068
www.mac3.it - e-mail: mac3@mac3.it
En
glish
Pressing ENTER, the value is saved in memory.
Keep pressed ENTER till it will be displayed “Done.…………”
and then it passes automatically to:
Premere ENTER per salvare tutti i parametri in memoria
permanente.
Keep pressed ENTER till it will be displayed
“Saving Param.…………” followed by
“Done.…………”
and then it passes automatically to:
Save & Exit
With ENTER
X.X Bar
yyyyyyyyyyyyyy
This is the standard visualization of the display:
-X.X Bar is the pressure value in the system
- yyyyyyyyyyyyyy is one of the messages defined
in paragraph 5.1
NB:. Only for HCMT:
If the device has been activated, check the sense of rotation of the pump;
if must modify the sense of rotation press key + for about 5 seconds, with key --> go to the
parameter Rotation Sense. With key + and – set the value desired for rotation sense(0000 or
0001)
Press ENTER, and keep pressed till it will be displayed “Done.…………”.